Three-Phase Distribution Board
Figure 5 shows the internal connections of a distribution board consisting of 3 three-phase MCB’s and 3 three-phase RCBO’s. It may be used to supply 6 balanced three-phase loads, 3 of which require RCD protection.
Related posts:
Operation of the Synchronous Motor
Signal-carrying switches:Reed switches
Introduction to AC:AC Waveform Values
Testing Motors in Place
Measurement:Playback Systems in Studios
Basic Logic Gates:Not Gate
POWER ELECTRONIC CONVERTERS FOR MOTOR DRIVES:D.C. FROM A.C. – CONTROLLED RECTIFICATION
Audio Amplifiers:Basic Junction Transistor Circuit Configurations
INDUSTRIAL INTELLIGENT CONTROLLERS:PLC (PROGRAMMABLE LOGIC CONTROL) CONTROLLERS
Synchronous Motor:Effect of Changing Excitation on Constant Load
Fuel Injection – Bosch D-Jetronic and L-Jetronic (ECGI) (part2)
POWER ELECTRONICS, RECTIFIERS, AND PULSE-WIDTH MODULATION INVERTERS:PULSE SYNCHRONIZATION AND VOLTAG...
CONTROL FUNDAMENTALS:BASIC TWO-POSITION CONTROL
Troubleshooting AC motors and starters:Motor failures and methods to extend its life