Standards
The performance requirements of power transformers are covered by a range of inter- national, regional and national standards. The main standards in IEC, CENELEC and BSI are shown in Table 6.3, together with their inter-relationship. Where appropriate, the equivalent ANSI/IEEE standard is also referenced.
Related posts:
The brushless servomotor.
The Efficient Use of Energy:Load Factor and Power Factor.
Testing and Commissioning of Protective Relays and Instrument Transformers:Protective Relays and Cla...
Wind Farm Protection:Wind Integration Dynamic Fault Studies
Thermal Loading of Several Multilevel Converter Topologies for 10 MW Wind Turbines Under Low Voltage...
The Current Situation and Perspectives on the Use of Hydropower for Electricity Generation:Norway
PISTON ENGINE–BASED POWER PLANTS:EMISSION CONTROL
Transformers:Main classes of transformer.
Underground Distribution:Installations and Configurations
Circuit-Level Transient Suppression:Protecting Low-Voltage Supplies.
Taxonomy of Uncertainty Modeling Techniques in Renewable Energy System Studies:Future Research
The Current Situation and Perspectives on the Use of Solar Energy for Electricity Generation:Belgium
Wires and cables:Parameters and test methods
NATURAL GAS–FIRED GAS TURBINES AND COMBINED CYCLE POWER PLANTS:GAS TURBINE PRINCIPLE
AN INTRODUCTION TO ELECTRICITY GENERATION:RENEWABLE ENERGY AND DISTRIBUTED GENERATION