Ducts and Duct Systems:Installing Damper Motors

Installing Damper Motors

The location of a damper motor will be determined by the design of the ductwork. If possible, the motor should be easily accessible for

Ducts and Duct Systems-0286

 

Ducts and Duct Systems-0287

servicing and maintenance. The following suggestions should be considered when seeking a location for a duct motor:

• The ambient temperature must be within the ratings of the motor being installed.

• A motor should not be installed where corrosive vapors or sprays, or other contaminants, may present a problem to motor operation. It is especially necessary to prevent dust or dirt from getting on the feedback potentiometer.

• The linkage between the motor and the damper must be free to operate without binding on pipes or other obstructions.

• The motor must be installed so that it is free to run from one end of its stroke to the other.

 

TableDucts and Duct Systems-0288 • Honeywell modutrol motors must be mounted with the shaft in a horizontal position.

• A remote balancing relay mounted on a firm support must be used if motor location is subject to severe vibration.

• Weatherproof motors should be used when the unit is located in a position exposed to the elements.

Leave a comment

Your email address will not be published. Required fields are marked *